File Details:
{"filename":"bsc-2-sem-cs-basic-electronics-np-3590-may-2019.pdf","title":"B.Sc. (Computer Science) IInd Semester Examination, May-2019","subject":"Basic Electronics (BCS-203)","total_questions":13}
Questions:
- Explain the Drift current and Mobility.
- What is the Ripple factor of Rectifier? Find the Ripple factor of half-wave rectifier.
- A transistor has an Ic of 100 mA and IB of 0.5 mA. What is the value of adc?
- Explain the JFET Parameters.
- Drive the output equation for Non-inverting summing amplifier.
- Find the concentration of holes and electrons in an N-type silicon at 300 K if the conductivity is 0.1 (ohm-cm)-1. Given that n; at 300 K for silicon = 1.5 x 101cm3, Le at 300 K for silicon = 1300 cm2/V-S.
- Describe the Ebers-Moll model of a bipolar junction transistor and explain the working of the transistor.
- Explain in brief, the construction and operation of MOSFET.
- Draw the circuit diagram of a Half-wave rectifier and calculate: Idc, Irms, Ripple factor, Efficiency of rectification, PIV rating of diode.
- What do you understand by Thermal Run-away? In what situations it can occur? Derive an expression for stability factor for a fixed bias circuit.
- Explain the Common Drain (CD) JFET Amplifier.
- Drive an expression for Adder-Subtractor circuit using OP-AMP.
- Write short notes on any three of the following: Bridge rectifier circuit, SVRR and CMRR, Intrinsic semiconductor, Emitter biasing.
Back to list
GKPAD.COM by SK Yadav | Disclaimer